Falcon F48 v5

Documentation

• Specification Sheet

Description

F48V5

48 Differential Outputs. Bi-Directional communication with all version 5 receivers connected in Smart Receiver Mode. The receivers report voltage, port current, firmware version, pixel counts and other useful information. Version 5 receivers can be updated over the wire. Can drive up to 32768 pixels from E131, DDP or Artnet (No restriction on the input type).  Embedded local SmartReceiver. Can connect up to 12 Falcon Differential SmartReceiver Chains.

Board current specs

Features 

• Bidirectional Communication with version 5 receivers.
• Embedded SRx1 V5 SmartReceiver.
• 192 Universes of E131, Artnet or DDP. No restrictions, same amount for all types of input.
• 2-Port Switch to "Daisy-Chain" controllers.
• Wireless ESP-07 Module with board mount antenna. Optional external antenna can be ordered.
• Falcon Player Remote Mode. The controller can store sequences on micro SD card and play in sync with FPP master. 
• Single 4-Layer Board.
• Ability to drive 12 SmartReceiver chains.

Power
Board can be powered from 5 or 7 - 13V, 3 amp minimum power supply. 

Local SmartReceiver

Built-In local SmartReceiver. Ports 45-48A are the local SmartReceiver Ports.


Number of ports
48 Ports. 
All ports can use any of the 98,304 channels this controller can receive as a start address.
Each string can be independently configured for null nodes, zigzag, forward/reverse, node type, pixel count , grouping etc...

Pixels per port
1024 maximum per port when in 32 port mode. 704 maximum per port when in 48 port mode.

Pixel Types

• Supported Pixel Types

DMX and Renard Outputs

1 - Dedicated RS-485 output. 1 RJ-45 connector.

LCD Display,Push Buttons and Indicators
.96" OLED 128x64 matrix display for setup and status.
5 - Push buttons to control display. Up, Down, Right, Left and Select
Power LED indicator
Two multi purpose LEDS for status.

Temperature Sensors

1 - Processor temperature sensor.
1 - Additional Sensor