Reference: SKU-PSK5MM
Brand: Build a Fright Show
Pneumatics Starter Kit - 6mm - for 16 and 25mm cylinders
Reference: SKU-PSK5MM
Brand: Build a Fright Show
Reference: SKU-PSK8MM
Brand: Build a Fright Show
An 8 port, high performance, low cost and good looking controller.
The Baldrick Board will output 750 pixels per port @ 40fps
The Baldrick Board has two 30amp power inputs 5-24v inputs (and the board will run on either input!) - allowing 7.5amp outputs
3 input buttons to trigger remote webhooks and activate onboard functions (FPP actions etc)
Fuse-good indicator lights for easy problem-finding
Wired 100Mb ethernet, for minimal network delay/jitter, especially with high data rates
Direct integration with xlights (2024.10 and later).
You can read more about the controller here: https://baldrickboard.com
This product is for a Baldrick Board only - it is also available with a PSU and Mount, and a complete build kit!
I've been playing with the Baldrick and have been very happy.
For the price it's a no brainer.
The onboard connections for buttons have so many helpful uses too, a nice little touch.
Reference: SKU-BBBwithPSU
Brand: iLightThat
Reference: SKU-BBBwithBuildKit
Brand: iLightThat
Reference: SKU-11919
Brand: Falcon & PixelController
48 Differential Outputs. Bi-Directional communication with all version 5 receivers connected in Smart Receiver Mode. The receivers report voltage, port current, firmware version, pixel counts and other useful information. Version 5 receivers can be updated over the wire. Can drive up to 32768 pixels from E131, DDP or Artnet (No restriction on the input...
Reference: SKU-BBBwithPSU
Brand: iLightThat
Reference: SKU-3
Brand: Falcon & PixelController
Reference: SKU-B17withBuildKit
Brand: iLightThat