4 Wire Seed Pixel Strings 100ct with pigtails - 100mm spacing - black

If you aren't a fan of soldering then this version of seed pixels is the answer!

New for 2025 - 4 wire redundant data pre-termimated 50 LED lengths (pigtail connectors)

Currently these are the new "thing" in the lighting community, because of their small form factor, brightness, power consumption and much more they are a very versatile product! There are many suppliers of seed lights, but we have tried and tested them all, and, as usual, only settled for the best. These have been submerged, frozen and exposed to our usual rigorous testing. They also have one main advantage over most of the cheaper equivelents - these run on 12v!! Couldn't ask for a lot more really! Perfect for using on your Christmas Trees, wrapping on wireframe, dressing bushes and so much more - the only limit is your imagination. They are available in a variety of spacings - so take a look at the whole range before buying!

When connecting these seeds to a controller, unlike 4 wire bullet pixels, please ensure you connect both the primary and backup wire to the data pin on the controller connection

We would also like to point out a few bits of feedback from users. If you are planning to make a tree from seed/pebble pixels, please note that the wire between these is thin, and NOT load bearing. If you make a tree with seeds/pebbles, please ensure you use a supporting wire, and attach the seeds/pebbles to that, rather than just spanning the seeds between 2 points, and worse still, applying tension to the seeds! We cannot support any warranty when used in this manner. Thanks.