PiHat Controller with RPi 4 2GB & SD Card with FPP Installed

What you get with this purchase:

1x ESP Artstick PiHat as described below
1x Raspberry Pi 4 2Gb Pi
1x genuine Sandisk 16Gb SD Card, preinstalled with FPP 5
1x £10 Gilbert Engineering gift voucher to redeem on the store on your next purchase

Want to run over 1024 pixels using FPP as standalone controller or networked with other pixel controllers but with a very small size?

This add on feature enhances the power of the Raspberry Pi family, to allow you to run FPP or other pixel controller software of your choice all in one tiny little controller. Using xLights or other software, you can link via LAN or Wireless to sync your sequenced pixels or servos to your show. Alternatively you can have the setup running as a stand alone controller with Web Interface accessibility. Using FPP, and this Raspberry Pi hat  allows you to remotely access and upload you sequences from xLights, control the schedule of your shows, control your pixels directly or even have them sync together with your entire show.

Each add on to your Raspberry has two outputs, both with Positive, Ground, and Data outputs and with the Raspberry Pi Zero you have two MicroUSB inputs. There is no need to power your Raspberry pi directly as you can power it directly from the hat!. This allows you to power your 12v pixels and the raspberry pi all from the hat, giving you that much need extra MicroUSB inputs you need.

With a dedicated data level amp, you will know you will have the power to light up your pixels with ease. Each output allows you to control over 512 pixels giving you 1024 pixels at a full 40 FPS!