- Pixel Controllers
- Gilbert Engineering Props
- Accessories & Hardware
- Costume & Wearables
- Other Products
- Build A Light Show Coro
WLED 5v - 12V Artstick SD-Card / WiFi Enhanced Edition pixel controller
Pixel controller allowing for the option of being a wireless pixel controller or stand alone Sequence Player from a SD card.
Allows for either 5 or 12 volt powered.
Allows for up to 32GB sdcard (not included).
With SD-Card plays up to 512 pixels at this time.
You can also change the firmware for WLED and others for WiFi controllable pixels.
In addition has hardware features for other software uses.
Program and Reset Button.
2.4 GHZ WiFi Pixel Controller
Data level shift for better pixel color and data control
Micro USB for easy programming
5 pin header screw terminal
Easy to read connectors for power and pixel connections
When powering on your EspArtStick use a laptop, tablet, or phone and go into your WiFi connection settings.
Password is wled1234
After connection, you will either get a new screen or will need to open up your internet browser and go to http://18.104.22.168
Update your WiFi router connection settings and set a static IP to use along with your routers gateway (normally 192.168.1.1)
Scroll to the bottom and check the disable WiFi Sleep, then click save and connect.
Go to your new Static IP address in your browser. Setup your LED count and other settings.
Make sure to go through your Sync setting for your E131.
In addition, you can also use the tool https://ledfx.app/ on your system for remote testing and other fun things.
Enable E1.31 support from the ‘Sync Settings’ page on the WLED web-interface.
Add the device as an E1.31 device.
If you have more than 170 LEDs click ‘Additional Properties’ and set the ‘Universe Size’ to 510.
No customer reviews for the moment.
Brand: BALS Essentials
Brand: ESP ArtStick
Want to run over 1024 pixels using FPP as standalone controller or networked with other pixel controllers but with a very small footprint?