- Awaiting new stock
- Pixel Controllers
- Gilbert Engineering Props
- Accessories & Hardware
- Costume & Wearables
- Other Products
- Build A Light Show Coro
- The OCO Department
- Build A Fright Show
5v - 12V Artstick SD-Card / WiFi Pro Edition (WLED pre-Installed)
WLED PRE-INSTALLED (Scroll down for setup and Usage)
Pro edition Pixel controller allowing for the long range wireless pixel controller and/or fast stand alone Sequence Player from a SD card. Use WLED, PixelStick, or custom firmware to suit your needs.
- allows for 5v - 12v power
- WEMOS D1 Mini Pro
- 3dBi 2.4ghz WIFI Antenna
- 100mm SMA Connector Cable
- SD Card reader slot up to 32 GB storage (Card not included)
- Shorter profile with solid build metal permanent terminal connectors
- Allows for upload or pre built firmware or custom code
- Data level shift for better pixel performance
- 5 - 12 power selection with dedicated power buck conversion
- IR Infrared
You can also change the firmware for WLED and others for WiFi controllable pixels.
In addition has hardware features for other software uses.
Program and Reset Button.
2.4 GHZ WiFi Pixel Controller
Data level shift for better pixel color and data control
Micro USB for easy programming
5 pin header screw terminal
Easy to read connectors for power and pixel connections
When powering on your EspArtStick use a laptop, tablet, or phone and go into your WiFi connection settings.
Password is wled1234
After connection, you will either get a new screen or will need to open up your internet browser and go to http://220.127.116.11
Update your WiFi router connection settings and set a static IP to use along with your routers gateway (normally 192.168.1.1)
Scroll to the bottom and check the disable WiFi Sleep, then click save and connect.
Go to your new Static IP address in your browser. Setup your LED count and other settings.
Make sure to go through your Sync setting for your E131.
In addition, you can also use the tool https://ledfx.app/ on your system for remote testing and other fun things.
Enable E1.31 support from the ‘Sync Settings’ page on the WLED web-interface.
Add the device as an E1.31 device.
If you have more than 170 LEDs click ‘Additional Properties’ and set the ‘Universe Size’ to 510.
Brand: BALS Essentials
Brand: ESP ArtStick
Want to run over 1024 pixels using FPP as standalone controller or networked with other pixel controllers but with a very small footprint?